A circuit partitioning algorithm with path delay constraints for multi-FPGA systems

研究成果: Article

3 引用 (Scopus)

抜粋

In this paper, \ve extend the circuit partitioning algorithm which we have proposed for multi-FPGA systems and present a new algorithm in which the delay of each critical signal path is within a specified upper bound imposed on it. The core of the presented algorithm is recursive bipartitioning of a circuit. The bipartitioning procedure consists of three stages: 0) detection of critical paths; 1) bipartitioning of a set of primary inputs and outputs; and 2) bipartitioning of a set of logic-blocks. In 0), the algorithm computes the lower bounds of delays for paths with path delay constraints and detects the critical paths based on the difference between the lower and upper bound dynamically in every bipartitioning procedure. The delays of the critical paths are reduced with higher priority. In 1), the algorithm attempts to assign the primary inputs and outputs on each critical path to one chip so that the critical path does not cross between chips. Finally in 2), the algorithm not only decreases the number of crossings between chips but also assigns the logic-blocks on each critical path to one chip by exploiting a network flow technique. The algorithm has been implemented and applied to MCNC PARTITIONING 93 benchmark circuits. The experimental results demonstrate that it resolves almost all path delay constraints with maintaining the maximum number of required I/O blocks per chip small compared with conventional algorithms.

元の言語English
ページ(範囲)494-505
ページ数12
ジャーナルIEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences
E80-A
発行部数3
出版物ステータスPublished - 1997 1 1

ASJC Scopus subject areas

  • Signal Processing
  • Computer Graphics and Computer-Aided Design
  • Electrical and Electronic Engineering
  • Applied Mathematics

フィンガープリント A circuit partitioning algorithm with path delay constraints for multi-FPGA systems' の研究トピックを掘り下げます。これらはともに一意のフィンガープリントを構成します。

  • これを引用