A study on modeling and analysis of kinematic motion deviations of machine tools (1st report, modeling and analysis of geometric deviations of constituting units)

Naoki Satonaka, Nobuhiro Sugimura, Yoshitaka Tanimizu, Koji Iwamura

研究成果: Article査読

3 被引用数 (Scopus)

抄録

The objective of the present research is to develop a systematic method for planning and analysis of kinematic motion deviations of machine tools based on geometric tolerances of three-dimensional components. This paper deals with the modeling and analysis of the geometric deviations of the toleranced components. The tolerance zones of the geometric features of the components are investigated and classified based on the definitions of the geometric tolerances. The parameters are defined to describe the deviations of the geometric features within the tolerance zones. An analytical method is proposed to estimate the statistic deviations of the positions and the orientations of the geometric features, based on the deviation parameters and the relationships between the datum features and the toleranced features.

本文言語English
ページ(範囲)2622-2628
ページ数7
ジャーナルNihon Kikai Gakkai Ronbunshu, C Hen/Transactions of the Japan Society of Mechanical Engineers, Part C
71
8
DOI
出版ステータスPublished - 2005 8月
外部発表はい

ASJC Scopus subject areas

  • 材料力学
  • 機械工学
  • 産業および生産工学

フィンガープリント

「A study on modeling and analysis of kinematic motion deviations of machine tools (1st report, modeling and analysis of geometric deviations of constituting units)」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル