CdTe stacked detectors for gamma-ray detection

Shin Watanabe, Tadayuki Takahashi, Yuu Okada, Goro Sato, Manabu Kouda, Takefumi Mitani, Yoshihito Kobayashi, Kazuhiro Nakazawa, Yoshikatsu Kuroda, Mitsunobu Onishi

研究成果: Article査読

30 被引用数 (Scopus)

抄録

We describe a stacked detector made of thin cadmium telluride (CdTe) diode detectors. By using a thin CdTe device, we can overcome the charge loss problem due to the small mobility and short lifetime of holes in CdTe or cadmium zinc telluride (CdZnTe) detectors. However, a CdTe detector with a thickness of more than 5 mm is needed for adequate detection efficiency for gamma-rays of several hundred keV. Good energy resolution and good peak detection efficiency are difficult to obtain using such a thick CdTe detector. The stacked detector enabled us to realize a detector with both high-energy resolution and good efficiencies for gamma rays up to several hundred keV. In order to verify this concept, we constructed a prototype made of ten layers of a 0.5-mm-thick CdTe diode detectors with a surface area of 21.5 mm × 21.5 mm. With this, we have achieved 5.3-keV and 7.9-keV energy resolution [full width at half maximum (FWHM)] at 356 keV and 662 keV, respectively, at the temperature of -20°C.

本文言語English
ページ(範囲)1292-1296
ページ数5
ジャーナルIEEE Transactions on Nuclear Science
49 II
3
DOI
出版ステータスPublished - 2002 6

ASJC Scopus subject areas

  • 電子工学および電気工学
  • 原子力エネルギーおよび原子力工学

フィンガープリント

「CdTe stacked detectors for gamma-ray detection」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル