Cutting performance of turning insert with three-arcs-shaped finishing edge

Wada Tadahiro*, Hiro Kazuki, Nakanishi Jun

*この研究の対応する著者

研究成果: Conference contribution

抄録

In the turning of a shaft with a step of specified corner R, it is important whether the corner radiuses of the turning insert is the same as the specified corner R or lower than it. A turning tool with a large corner radius cannot adapt to cutting a shaft with a step of specified corner R. In this study, the surface roughness, cutting force, and tool wear were experimentally investigated in order to clarify the cutting performance of the turning insert with a three-arcs-shaped finishing edge. The machined surface of the insert with a three-arcs-shaped finishing edge was better than that of the normal insert. The wear progress of the insert with an arc-shaped finishing edge was slightly slower than that of the normal insert. The cutting force of the insert with an arc-shaped finishing edge was almost the same as that of the normal insert.

本文言語English
ホスト出版物のタイトルMechanical and Aerospace Engineering
ページ1630-1636
ページ数7
DOI
出版ステータスPublished - 2012
外部発表はい
イベント2nd International Conference on Mechanical and Aerospace Engineering, ICMAE 2011 - Bangkok, Thailand
継続期間: 2011 7月 292011 7月 31

出版物シリーズ

名前Applied Mechanics and Materials
110-116
ISSN(印刷版)1660-9336
ISSN(電子版)1662-7482

Conference

Conference2nd International Conference on Mechanical and Aerospace Engineering, ICMAE 2011
国/地域Thailand
CityBangkok
Period11/7/2911/7/31

ASJC Scopus subject areas

  • 工学(全般)

フィンガープリント

「Cutting performance of turning insert with three-arcs-shaped finishing edge」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル