Design of a 300-mV 2.4-GHz receiver using transformer-Coupled techniques

Fan Zhang, Yasunori Miyahara, Brian P. Otis

研究成果: Article査読

28 被引用数 (Scopus)

抄録

This paper presents a 1.6-mW 2.4-GHz receiver that operates from a single supply of 300 mV allowing direct powering from various energy harvesting sources. We extensively utilize transformer coupling between stages to reduce headroom requirements. We forward-bias bulk-source junctions to lower threshold voltages where appropriate. A single-ended 2.4 GHz RF input is amplified and converted to a differential signal before down-converting to a low IF of 1 to 10 MHz. A chain of IF amplifiers and narrowband filters are interleaved to perform programmable channel selection. The chip is fabricated in a 65-nm CMOS process. The receiver achieves - 91.5-dBm sensitivity for a BER of 10e-3.

本文言語English
論文番号6613557
ページ(範囲)3190-3205
ページ数16
ジャーナルIEEE Journal of Solid-State Circuits
48
12
DOI
出版ステータスPublished - 2013 12
外部発表はい

ASJC Scopus subject areas

  • Electrical and Electronic Engineering

フィンガープリント 「Design of a 300-mV 2.4-GHz receiver using transformer-Coupled techniques」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル