Designing a low-noise gearbox by using sound-radiation analysis of a gear system

Eiichirou Tanaka, Haruo Houjoh

研究成果: Article査読

1 被引用数 (Scopus)

抄録

A method for predicting gear noise produced by a gear system was developed. This method calculates the distribution of sound pressure around the gearbox and identifies the areas from which noise radiates intensely. According to the sound-power level calculated from this pressure distribution, a low-noise gearbox was designed by adding ribs. The appropriate adding points were then calculated from the viewpoint of mass variation. It was found that to decrease the noise, ribs should be added in two places: (i) along the line with maximum curvature through the antinode of the gearbox's vibration mode or (ii) the minimum-length line which crosses the most contour lines through the maximum point of the sound-pressure contour map. It was also found that in the case of a gearbox with a vibration mode in which the gearbox side faces vibrate in opposite directions, noise can be effectively reduced by connecting the ribs on both side faces.

本文言語English
ページ(範囲)1861-1867
ページ数7
ジャーナルNippon Kikai Gakkai Ronbunshu, C Hen/Transactions of the Japan Society of Mechanical Engineers, Part C
70
6
DOI
出版ステータスPublished - 2004 6
外部発表はい

ASJC Scopus subject areas

  • Mechanics of Materials
  • Mechanical Engineering
  • Industrial and Manufacturing Engineering

フィンガープリント 「Designing a low-noise gearbox by using sound-radiation analysis of a gear system」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル