Effect of Mirror Facets on Lasing Characteristics of Distributed Feedback InGaAsP/lnP Laser Diodes at 1.5 μm Range

Katsuyuki Utaka, Shigeyuki Akiba, Kazuo Sakai, Yuichi Matsushima

研究成果: Article査読

97 被引用数 (Scopus)

抄録

The effect of mirror facets on lasing properties of distributed feedback (DFB) InGaAsP/lnP laser diodes was studied theoretically and experimentally. A DFB laser with a window region was found to be suitable to examine the effect of mirror facets. The effective reflectivity of a window structure was calculated to be very small, typically as small as 0.03 percent for a few tens of micrometers of the window region. These small effective reflectivities were experimentally confirmed. Three kinds of DFB lasers, i.e., a double-window (DW), a single-window (SW), and a Fabry-Perot (FP), were discussed. Two modes with a separation corresponding to a so-called stopband appeared in a DW-DFB laser, in which almost no reflection at both ends was estimated. On the other hand, the threshold and the resonant wavelength of an SW- and an FP-DFB laser were found to be sensitive to the phases of corrugation at the facets. It turned out, however, that the mirror facet contributed to the single-mode operation due to an asymmetric resonant spectrum and to the reduction in the threshold. Although a low-threshold-current FP-DFB laser was experimentally obtained, the coincidence between the gain peak and the Bragg wavelengths was essential in this type. The SW-DFB laser seemed the most promising among the three types in terms of the stability of the singlemode operation.

本文言語English
ページ(範囲)236-245
ページ数10
ジャーナルIEEE Journal of Quantum Electronics
20
3
DOI
出版ステータスPublished - 1984 3月
外部発表はい

ASJC Scopus subject areas

  • 原子分子物理学および光学
  • 凝縮系物理学
  • 電子工学および電気工学

フィンガープリント

「Effect of Mirror Facets on Lasing Characteristics of Distributed Feedback InGaAsP/lnP Laser Diodes at 1.5 μm Range」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル