Effects of molding pressure and sintering temperature of silicon particles on oil content and lubricating characteristics of particle-dispersed aluminum sintered

Kenichi Tsuru*, Susumu Matsumoto

*この研究の対応する著者

研究成果: Article査読

1 被引用数 (Scopus)

抄録

A clear yield point was not seen in the tensile strength of the aluminum sintering body. As for the molding pressure, 170MPa was the upper limit value. Hardness, the radial crushing strength increased, but the oil content. As for the sintering temperature, 545°C were the upper limit values. Hardness, the radial crushing strength increased, but the oil content increased to 545°C, too. The friction examination of molding pressure 170MPa showed limit PV value 6.46MPa.m/s. The friction examination of sintering temperature 545°C showed aspect pressure 17MPa. The life examination maintained friction temperature to approximately 40°C until 30hours.

本文言語English
ページ(範囲)875-880
ページ数6
ジャーナルZairyo/Journal of the Society of Materials Science, Japan
59
11
DOI
出版ステータスPublished - 2010 11

ASJC Scopus subject areas

  • 材料科学(全般)
  • 機械工学
  • 材料力学
  • 凝縮系物理学

フィンガープリント

「Effects of molding pressure and sintering temperature of silicon particles on oil content and lubricating characteristics of particle-dispersed aluminum sintered」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル