Fabrication and electrochemical properties of layer-by-layer deposited films containing phthalocyanine dyes

Kazunari Shinbo*, Ken Onishi, Shunsuke Miyabayashi, Kazuki Takahashi, Shigenobu Katagiri, Keizo Kato, Futao Kaneko, Rigoberto C. Advincula

*この研究の対応する著者

研究成果: Article査読

31 被引用数 (Scopus)

抄録

Ultrathin films containing water-soluble copper (II) phthalocyanine-3,4′,4″,4‴- tetrasulfonic acid (CuPcTs) and poly(diallyldimethylammonium chloride) (PDADMAC) were fabricated using the electrostatic layer-by-layer deposition technique. UV-vis absorption spectra and ellipsometry measurements suggested successive linear depositions of the bilayers of CuPcTs and PDADMAC. The thickness of the CuPcTs monolayer obtained from the ellipsometry was smaller than the plain size of CuPcTs and the molecule planes were considered and tilted in the film. The surface morphology was also observed using atomic force microscopy. The cyclic votammogram (C-V) of the fabricated films in 0.1 M KCl aqueous solution suggested the oxidation and reduction of the CuPcTs at approximately +0.9 and +0.05 V vs. Ag/AgCl, respectively. UV-vis absorption spectra were observed for the films at applied voltages of +0.9 and 0.0 V in the KCl aqueous solution and electrochromisms were repeatedly observed.

本文言語English
ページ(範囲)177-181
ページ数5
ジャーナルThin Solid Films
438-439
DOI
出版ステータスPublished - 2003 8月 22
外部発表はい

ASJC Scopus subject areas

  • 表面、皮膜および薄膜
  • 凝縮系物理学
  • 表面および界面

フィンガープリント

「Fabrication and electrochemical properties of layer-by-layer deposited films containing phthalocyanine dyes」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル