Foldable Kirigami Paper Electronics

Tilo H. Yang, Hikaru Hida, Daiki Ichige, Jun Mizuno, C. Robert Kao, Jun Shintake

研究成果: Article査読

抄録

Significant attention is focused on paper electronics (PEs) for developing flexible and recyclable devices. These devices use paper as the substrate on which electrode materials are successively patterned. Among various conductive materials used for PEs, nanosilver ink is the most commonly used material due to its low cost and easy printing process. However, nanosilver electrodes tend to fracture when a paper substrate is bent or folded, leading to disconnections in printed circuits. To maintain the integrity of the circuit pattern during folding, a novel Kirigami fabrication method for PEs is proposed, in which a paper substrate is prepared by cutting along the edge of the printed electrode prior to use. The Kirigami method is experimentally proven to turn the deformation mode of nanosilver electrodes from bending to twisting, which effectively prevents electrodes from fracture. Experimental measurements reveal that the electrical resistance of the Kirigami electrode increases by merely 30% under full folding. Conductivity is maintained after full folding for 100 cycles. Finally, the Kirigami strategy is applied to different foldable PEs including angle sensors, electrostatic actuators, and locomotion robots. The successful implementation of the Kirigami strategy demonstrates high potential for use in diverse PEs with complicated foldable 3D architectures.

本文言語English
論文番号1900891
ジャーナルPhysica Status Solidi (A) Applications and Materials Science
217
9
DOI
出版ステータスPublished - 2020 5 1

ASJC Scopus subject areas

  • 電子材料、光学材料、および磁性材料
  • 凝縮系物理学
  • 表面および界面
  • 表面、皮膜および薄膜
  • 電子工学および電気工学
  • 材料化学

フィンガープリント

「Foldable Kirigami Paper Electronics」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル