Magnetic properties of electroless-deposited NiFeB and electrodeposited NiFe alloy thin films

Madoka Takai*, Kensuke Kageyama, Sanae Takefusa, Akiyoshi Nakamura, Tetsuya Osaka

*この研究の対応する著者

研究成果: Article査読

16 被引用数 (Scopus)

抄録

The magnetic properties and the structure of electroless-deposited NiFeB films were investigated in comparison with those of electrodeposited NiFe films. The electroless-deposited NiFeB film with 27at% Fe content had the lowest coercivity, Hc, as low as 0.5 Oe with a saturation magnetic flux density, Bs, of 1.0 T. The saturation magnetostriction, λs, and the uniaxial magnetic anisotropy, Hk, were 5.0×10-6 and 10 Oe, respectively, which were larger than those of the conventional, electrodeposited permalloy film. The permeability of as-deposited Ni70Fe27B3 film was 1000 at 1 MHz. In order to improve the permeability, the film was heated at 200 °C in a magnetic field applied in the hard-axis direction to decrease the Hk value, and the permeability became 2000 at 1 MHz. The crystal structure and grain size of NiFeB and NiFe films were investigated by XRD, THEED and TEM. Both films with low Hc had an fcc structure; the grain size of the NiFeB film was smaller than 10 nm, while that of the NiFe film was larger, approximately 20 nm. The results suggested that the electroless-deposited NiFeB film had a larger magnetic anisotropy than the electrodeposited NiFe film. Moreover, the films with Hc less than 10 Oe did not show clear difference between their TEM bright images and THEED patterns.

本文言語English
ページ(範囲)1530-1535
ページ数6
ジャーナルIEICE Transactions on Electronics
E78-C
11
出版ステータスPublished - 1995 11 1

ASJC Scopus subject areas

  • 電子材料、光学材料、および磁性材料
  • 電子工学および電気工学

フィンガープリント

「Magnetic properties of electroless-deposited NiFeB and electrodeposited NiFe alloy thin films」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル