Power optimization of sequential circuits using switching activity based clock gating

Xin Man, Takashi Horiyama, Shinji Kimura

研究成果: Article査読

2 被引用数 (Scopus)

抄録

Clock gating is the insertion of control signal for registers to switch off unnecessary clock signals selectively without violating the functional correctness of the original design so as to reduce the dynamic power consumption. Commercial EDA tools usually have a mechanism to generate clock gating logic based on the structural method where the control signals specified by designers are used, and the effectiveness of the clock gating depends on the specified control signals. In the research, we focus on the automatic clock gating logic generation and propose a method based on the candidate extraction and control signal selection. We formalize the control signal selection using linear formulae and devise an optimization method based on BDD. The method is effective for circuits with a lot of shared candidates by different registers. The method is applied to counter circuits to check the co-relation with power simulation results and a set of benchmark circuits. 19.1-71.9% power reduction has been found on counter circuitsafter layout and 2.3-18.0% cost reduction on benchmark circuits.

本文言語English
ページ(範囲)2472-2480
ページ数9
ジャーナルIEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences
E93-A
12
DOI
出版ステータスPublished - 2010 12

ASJC Scopus subject areas

  • Signal Processing
  • Computer Graphics and Computer-Aided Design
  • Electrical and Electronic Engineering
  • Applied Mathematics

フィンガープリント 「Power optimization of sequential circuits using switching activity based clock gating」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル