Precise location of the excessive temperature points in polymer insulated cables

Yoshimichi Ohki, Takayuki Yamada, Naoshi Hirai

研究成果: Article査読

38 被引用数 (Scopus)

抄録

This paper demonstrates that it is possible to locate very precisely a point showing a high temperature in a polymer insulated cable. The method is based on frequency domain reflectometry and inverse fast Fourier transform. The cables tested are a coaxial communication cable with a length of 32 m insulated by low density polyethylene and a flat in-house electric cord with a length of 21 m insulated by polyvinyl chloride. The cable or cord was heated at different positions for different lengths. The ratio between the powers of electromagnetic waves incident to and reflected from the cable was measured using a network analyzer in a frequency range from one to several hundred MHz or 1.5 GHz. The spectra obtained by the measurements were then analyzed by inverse Fourier transform. As a result, the position exhibiting a temperature higher than the adjacent points can be located with a spatial resolution as short as 2.5 cm. It was also confirmed that the sensitivity or spatial resolution can be improved by an increase of the highest measurement frequency.

本文言語English
論文番号6678858
ページ(範囲)2099-2106
ページ数8
ジャーナルIEEE Transactions on Dielectrics and Electrical Insulation
20
6
DOI
出版ステータスPublished - 2013 12月

ASJC Scopus subject areas

  • 電子工学および電気工学

フィンガープリント

「Precise location of the excessive temperature points in polymer insulated cables」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル