Proposal of a design methodology for modularity using geometric information

Keita Tonoike, Shinichi Fukushige, Yasushi Umeda

研究成果: Paper査読

抄録

In these days, modular design of a product is becoming important even for environmental conscious design in order to improve, e. g., reusability, disassemblability, and recyclability. In order to derive a feasible module structure, not only environmental aspects but also geometric information bears important roles. This paper presents a modular design methodology for life cycle engineering that proposes module structure by using information on geometry and product life cycle. The case study of an inkjet printer revealed that the derived modular structure satisfies the various demands from product life cycle with keeping the geometric consistency.

本文言語English
出版ステータスPublished - 2007
外部発表はい
イベント4th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2007 - Fukuoka, Japan
継続期間: 2007 11 72007 11 9

Other

Other4th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2007
国/地域Japan
CityFukuoka
Period07/11/707/11/9

ASJC Scopus subject areas

  • 産業および生産工学

フィンガープリント

「Proposal of a design methodology for modularity using geometric information」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル