Self-Powered Artificial Sensory Nervous System Using Ring Oscillator for Pulse Density Modulation

Shunsuke Yamada, H. Toshiyoshi

研究成果: Article

3 被引用数 (Scopus)

抄録

Unlike typical sensor electronics that always require a voltage source for sensors, amplifiers, and analog-digital converters, we use a mechano-electric transducer as a sensor and also in place of a power source to drive the rest of the electronics, thereby realizing an autonomous self-powered artificial sensory nervous system. A piezoelectric (lead zirconate titanate oxide) PZT is used as an inertia sensor that produces a voltage signal as a function of the acceleration of incoming vibrations. The PZT output current is rectified and stored in a capacitor to develop a time-varying dc voltage of typically upward of 1 V, which is used to drive a subsequent three-stage ring oscillator. The running frequency of the ring oscillator is voltage-controlled by three orders of magnitude from 2.1 kHz to 1.3 MHz within a single period of the sinusoidal waveform of acceleration that has the acceleration of 9 m/s2at 160 Hz. By repeatedly counting the number of pulses in an every 6.3-ms time frame, the original waveform of the incoming acceleration is reproduced as a digital data. Dynamic range is defined by the frequency shift from 2.1 kHz to 3 MHz when the acceleration amplitude is changed from 6 to 12 m/s2 , thereby yielding a sensitivity of 240 m/s2 /m.

本文言語English
論文番号8013787
ページ(範囲)1477-1480
ページ数4
ジャーナルIEEE Electron Device Letters
38
10
DOI
出版ステータスPublished - 2017 10 1
外部発表はい

ASJC Scopus subject areas

  • Electronic, Optical and Magnetic Materials
  • Electrical and Electronic Engineering

フィンガープリント 「Self-Powered Artificial Sensory Nervous System Using Ring Oscillator for Pulse Density Modulation」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル