Structural change and improvement of the mechanical properties of a lotus-type porous copper by wire-brushing

J. Lobos*, S. Suzuki, H. Nakajima, Y. S. Ji, H. Fujii, D. Terada, N. Tsuji

*この研究の対応する著者

研究成果査読

12 被引用数 (Scopus)

抄録

The surface of lotus-type porous copper plates that had cylindrical open pores in the thickness direction (porosity 50.4%, average pore diameter 144.4 μm) were processed by wire-brushing. Open pores on the surface of the lotus copper are closed by a newly formed nonporous thin layer. Electron backscatter diffraction patterns of the processed plate cross section show that the deformed surface consists of ultra-fine grains and that a nonporous layer was formed on the deformation of the surface layer. The Vickers hardness of the wire-brushed lotus copper is higher than that of the wire-brushed non-porous copper. The Vickers hardness increases with the increase in the rate of revolution of the wire-brush due to grain refinement. The increment of the ultimate tensile strength of lotus copper by wire-brushing is larger than of non-porous copper. The increment of ultimate tensile strength of the lotus copper reaches maximum when the newly deformed layer closes all the pores on the surface. These results show that wire-brushing is an effective process for the improvement of mechanical properties for lotus metals.

本文言語English
論文番号012070
ジャーナルJournal of Physics: Conference Series
165
DOI
出版ステータスPublished - 2009 1 1
外部発表はい

ASJC Scopus subject areas

  • 物理学および天文学(全般)

フィンガープリント

「Structural change and improvement of the mechanical properties of a lotus-type porous copper by wire-brushing」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル