Study of anatomical landmark sampling error effect on motion measurement reproducibility for Orthopaedic physical examination assisting system

Jun Okamoto*, Yu Kumasaka, Kazuya Kawamura, Tomoyuki Matsumoto, Seiji Kubo, Hirotsugu Muratsu, Masahiro Kurosaka, Masakatsu G. Fujie

*この研究の対応する著者

研究成果: Article査読

抄録

We have been developing the Orthopaedic physical examination assisting system using magnetic position tracker to quantitate knee laxity diagnosis. In this study, to investigate the influence of anatomical landmark sampling error for bone coordinate registration, reproducibility verification simulation was done. Firstly, the motion data of imitation bones was acquired using the system and set as a reference data. To get the error motion data, virtual error vectors were added on the reference sampling points and new motion data was recomputed. Evaluation was executed by comparison with the reference data and recomputed data. The evaluation results lead improvement methods of measurement reproducibility as follows. 1. It is important to point the landmarks proximal to the knee carefully because the contribution of the motion error is higher than the distal landmarks. 2. To reduce the registration error, thigh and shank receivers should be set close to the knee as possible. 3. If the allowance area of the sampling error is in 2.0 mm diameter circle, Diagnosis error using IKDC Knee examination form is approximately 20 %.

本文言語English
ページ(範囲)3780-3793
ページ数14
ジャーナルNihon Kikai Gakkai Ronbunshu, C Hen/Transactions of the Japan Society of Mechanical Engineers, Part C
77
782
出版ステータスPublished - 2011
外部発表はい

ASJC Scopus subject areas

  • 機械工学
  • 材料力学
  • 産業および生産工学

フィンガープリント

「Study of anatomical landmark sampling error effect on motion measurement reproducibility for Orthopaedic physical examination assisting system」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル